It however does not have issues maintaining the temperature when it’s not actually printing. I can set my hotend to 215 before beggining my print and it’s happy to sit there.
Other problems with it include under extrusion and extruder skipping, as it seems to have troubles pushing the filament out.
What does this sound like it could be? Does it sound like a blockage? Could a blockage cause temperature issues? I have already tried turning off the part cooling fan as I had a similar issue with that a while back but that has no made a difference it seems.
That’s usually a bad thermistor or thermistor autre breaking.
Hmm I hadn’t considered that the reading could be wrong, I’ll pull apart my hotend later today to have a look at it.
It’s a pretty new printer though, I’d be surprised if I have managed to wear down the wire yet, but still I’ll have a look.
Does your Ender 3 still have the screwed-on-cable type of thermistor? These ones break when overtightened, which can happen at the factory.
If the cable and thermistor is turns out to be fine, run a PID tuning.