Seam is at another position, far away from that part.

Checked the screws and tightend them up a bit.

Just a band. But not all the was around. It is at overhangs and a little bit after them. But not before overhangs.

Started the print again because i need this part multiple times anyway. It starts to “fail” at the same corner again.

Edit: Not exactly the same damage, but at the same height. Looking at the last print, it’s not just that corner, it’s all around at the same height.

Thanks for your detailed answer. I’ll probably need about 50-100 pieces each. I got an good deal for some 250g spools on aliexpress, should be enough.

What exactly is the difference to just printing it standing?

How long did you have to wait for your printer? Mine is still stuck somewhere between Bambu and DPD.

Haven’t thought about it. But that might be a better idea. Do you need a special paint for PLA?